For most users, the maintenance and upkeep of the cement hollow brick machine in the later stage is very troublesome and cumbersome. However, we still need to do this work because only by doing a good job in the maintenance and upkeep of the cement hollow brick machine can we ensure the quality and performance of the equipment. One of its important components, the bearing, needs to be dismantled and replaced regularly. However, there are strict operating procedures during the dismantling process. If the dismantling is wrong, it is very likely to fail to achieve the effect of maintenance and upkeep, directly leading to premature damage to the bearing. Today, we will specifically explain how to disassemble the cement hollow brick machine bearing.
Firstly, when disassembling and washing, we should tighten some outer ring compression screws around the outer shell, and then slowly tighten these screws. This helps us to slowly disassemble the outer ring. For some bearings that have a protective effect on the outer shell, for some reasons, we can use a press or slow tapping to disassemble. After disassembly, a press can also be used inside the inner ring. However, one fact that we need to pay attention to is that even if the inner ring of the bearing is subjected to uniform force, failure to pay attention can still lead to damage. In addition, due to different manufacturers of cement hollow brick machines, the bearings installed inside may also differ, and in terms of disassembly and installation, it is also different, It is recommended that everyone carry out disassembly and safety work under the guidance of technical personnel from the cement hollow brick machine manufacturer.
CN
EN
